ELECTRICAL

Extend your best adventures into the after-hours. Easily install a 10'' light bar onto your Front Runner roof rack using the 10'' LED Light Bar VX250-FL Mounting Bracket.

Securely mount your 40'' LED Light Bar (VX1000-CB) to the front or underneath your Front Runner Roof Rack with this Single Mount bracket. These brackets feature a protective cover to shield the light bar against small rocks.

Easily secure your 40'' LED Light Bar to the front or underneath your Front Runner Roof Rack with these brackets. They feature a protective cover to shield the light bar against small rocks when not in use.

Distributor Cap, Suit 43D, 45D & 59D Distributor Land Rover Series 3, Defender 4 cylinder

Electronic Ignition Kit, 4 Cyl, 25D Dist Electronic Ignition Conversion Kit Suit 23D & 25D type distributor aka RTC3875K

Flasher Lamp, Front & Rear (no bulb) - Land Rover Series 1, 2, 2A, 3, Perentie, Defender up to 1994 Amber indicator Lamp for front & rear Bulb sold separately

Headlamp Bucket (Bowl) Suit 7″ Lamps  This plastic bucket kit includes the inner rim to hold the light unit in place. The headlamp outer rim is not included in the kit. Qty 2 required per car Land Rover Defender 1983 – 2006, Series 2, Series 2A, Series 3

Headlamp Sealed Beam, 7” Halogen - Land Rover Series 1, Series 2, Series 3, Defender

Headlamp, 7″ Sealed Beam - Land Rover Series 1, Series 2, Series 3, Defender

Ignition Condenser (LUCAS) - Defender , Range Rover Classic , Land Rover Series 2, 2A, 3

Key / Remote Pad Cover Discovery 3 and 4 Replaces worn pad on key

Key / Remote Pad Cover Range Rover Replaces worn pad on key

Install the 4.5W LED Rock Light on your Slimline II or Slimsport Rack Handle Bracket for extra nighttime visibility.

LH Headlight for Land Rover Freelander 2. Genuine part. Not second hand just old stock.

Pump, Windscreen Washer – Discovery 2, Defender & Freelander

Plug and Play No need for Adaptation Designed for MY 2001…2009 (BMW ideology). Plug & Play. Manages bus wakeup, key presence monitoring and key turn enable according to EWS status. 12-pin connector: plugs directly into original connector, pin1 is marked on opposite side of board. Wire to 1st pin is usually BLUE in original car wiring loom. Emulator is reusable (not locked to car).