STEERING & SUSPENSION

Plug and Play No need for Adaptation Designed for MY 2001…2009 (BMW ideology). Plug & Play. Manages bus wakeup, key presence monitoring and key turn enable according to EWS status. 12-pin connector: plugs directly into original connector, pin1 is marked on opposite side of board. Wire to 1st pin is usually BLUE in original car wiring loom. Emulator is reusable (not locked to car).

The Llams electronic air suspension height controller allows selection of off-road and high-speed   heights at any speed.   Sand, tracks and high-crown outback roads can now be driven at either full off-road height or a lesser 30 mm raised height without the normal 50 kph speed restriction then return to on-road height when conditions are suitable. Raised by 30 mm provides improved ride on rough tracks due to more bump-stop clearance. High speed lowered height provides improved on-road handling without the usual high speed requirement and when used with Access mode it provides improved access for young children and the mobility-impaired.

DISCOVERY 5 ELECTRONIC HEIGHT CONTROL KIT The Llams electronic air suspension height controller allows selection of off-road and high-speed   heights at any speed.

The Llams electronic air suspension height controller allows selection of off-road and high-speed   heights at any speed.   Sand, tracks and high-crown outback roads can now be driven at either full off-road height or a lesser 30 mm raised height without the normal 50 kph speed restriction then return to on-road height when conditions are suitable. Raised by 30 mm provides improved ride on rough tracks due to more bump-stop clearance. High speed lowered height provides improved on-road handling without the usual high speed requirement and when used with Access mode it provides improved access for young children and the mobility-impaired.

The system modifies the height sensor signals, offsetting each of the 4 valves to cause the suspension module to believe that the vehicle is lower or higher than it really is & therefore adjust the air volume in the air springs until the modified sensor signals are as expected for the target height. The system does not communicate with nor modify the suspension module, thereby retaining unaltered all original plausibility and control checks.

Uprated rear anti roll bar conversion kit, for the Land Rover Defender 110. Designed & tested to deliver the precise torsional stiffness required to keep a Defender upright, and yet still deliver a forgiving ride. Our German made anti roll bar is supplied complete with SuperPro bushes, to help give your Land Rover a much sharper turn in, and give you much more confidence on the road. Also available for the Defender 90.